The Ecosoft proportional dosing station is used for proportional supply of reagents into the line with variable water consumption (e.g. dosing of sodium hypochlorite, sodium sulfite, pH adjusting agents). Proportional dosing is performed upon a signal from a pulse flowmeter.
Reliable and easy-to-use
Adjustable injection frequency
Protection against power surge and peak voltage
Chemical resistance of the pump elements to aggressive substances
Technical characteristics of the dosing pump
constant / proportional
Nominal back pressure (Pnom), bar
Flow rate at Pnom, L/h
Maximum back pressure (Pmax), bar
Flow rate at Pmax, L/h
Volume of one injection, mL
Injection frequency, injections/min
Suction height (max), m
Noise level, dBA
Dosing pump power, W
230 V, 50 Hz
Temperature limit within the premises, °С
Temperature limit during storage / transportation, °С
Temperature of dosing solutions, °С
Material of components which contact with the dosing substance
FPM (Viton® B) or EPDM
Reagents tank volume, L
Reagents tank dimensions (diameter x height), mm
Dosing pump dimensions (width x depth x height), mm
Technical characteristics of standard impulse flowmeter1
Volume flow of water in the pipeline, m3/h
Impulse step, L/imp
Maximum water temperature in the pipeline, °С
horizontal / vertical
1 Flowmeters of different size and impulse step are available
Components of the station:
Dosing pump with pulse input
Foot filter with suction valve
Set of tubes for connection
Reagent solution tank
Operation of the dosing station presents accurate supply of small volumes of reagents from the tank into the water flow line with a dosing pump. The dosing pump sucks the solution out of the reagent tank, and delivers its certain volume to the system.
A filter is installed at the suction valve of the dosing pump to prevent sediments from entering the pump resulting in its clogging.
For sound and durable operation of the dosing station it is necessary to control the level of the solution in the reagent tank to prevent an emergency shutdown of the station.
If the reagent is going to be changed (and the pump materials allow that), the dosing station must be washed well with water to remove remains of previous solutions.
It is necessary to add the new portion of the solution to the reagent tank when there is still some solution left in it. The current volume of the solution in the tank should be taken into consideration when calculating the volume of water and reagents.
It is necessary to regularly clean and wash the foot filter installed at the suction valve of the dosing pump.