• About us
  • For partners
  • For consumers
  • Products
Ecosoft
Still have questions?
Article : MO550PECOST

Wholesale Ecosoft Standard reverse osmosis filter with pump

NUMBER OF PURIFICATION STAGES
5
MEMBRANE CAPACITY
50
EQUIPMENT
With pump
289
€289

Reverse osmosis is the most effective technology for drinking water purification. It reduces 99.8% of impurities, as well as odors, flavors, and viruses making water clear, clean, tasty and safe for human health, both adults and children. Along with that, the reverse osmosis filter is one of the most cost-effective methods of domestic water purification.

Advantages of the Ecosoft Standard reverse osmosis filter

  • Ecosoft membrane — Ukrainian water treatment market leader

  • 5 stages of water purification

  • 7.9 L of drinking water per hour

  • Up to 7 L storage tank

  • Delicious taste of water thanks to included coconut shell carbon filter

  • Domestic pump included

  • Filter housing made of pure European food grade plastic

  • Special vacuum tightness control

Benefits of using the filter

  • Source of absolutely clean and safe drinking water

  • Dishes cooked with the water will taste better

  • Coffee beans and tea leaves will open up their flavors and aroma

  • Home appliances (kettle, iron, steam cooker, air humidifier etc.) will be protected from scale

  • The clean water can be used to water flowers

Certain users of reverse osmosis filters doubt that so thoroughly purified water can supply human organism with important minerals. But scientists have proved up to 90% of minerals are provided with food, not water.



Components of the filter

  1. Filtration module with domestic pump

  2. Plastic storage tank (general vol. 12 L, effective vol. up to 7 L)

  3. Chrome ball valve faucet ‘Droplet’ for purified water

  4. Included feed water adaptor with feed valve for connection with water mains

  5. Ball valve faucet of storage tank

  6. Set of color tubes (4 pc.) for convenient filter installation

  7. Drain saddle clip for connection of the filter to sewers

  8. Set of replacement pre-filters (1st, 2nd, 3rd stages)

  9. Ecosoft membrane 50 GPD (190 L per day)

  10. Service wrenches for replacement of filters and the membrane

  11. Instruction manual

The model is supplied with domestic pump intended for water mains with low pressure. The pump will provide the pressure necessary for pushing water through the membrane.

Stages of water purification

The feed water flows through the three pre-filters intended to reduce sediments (rust, sand, silt etc.), chlorine and chlorination by-products, as well as organic matter.

The fourth stage is represented by the reverse osmosis membrane which at the molecular level purifies the water from 99.8% impurities including bacteria and viruses. The purified water is supplied to the storage tank.

The carbon post-filter is the fifth stage of the water treatment. It contains high-quality activated coconut shell carbon which improves purified water taste and odor, and adds slight sophisticated sweetish flavor.   

Characteristics

Inlet pressure for filter without pump, atm

3–6

Inlet pressure for filter with pump, atm

2–4.5

Pressure in storage tank, atm

0.4–0.6*

Temperature of feed water, °C

+4…+30**

Filter weight (basic configuration), kg

6

Temperature of environment limit, °C

+5…+40**

Water supply external connection, inches

thread, ½

Dimensions of filter, HxWxD (basic configuration), mm

455x410x195   

Dimensions of tank, HxWxD, mm

350x260x260


* If the pressure is lower or higher than indicated, it is necessary to pump up or release the pressure.

** If the temperature of feed water is within the range +20…+30 °C, selectiveness of the membrane insignificantly decreases, and capacity increases leading to insignificant growth of the TDS indicator. Application of the filter when the temperature of feed water exceeds +30 °C is not recommended.



The reverse osmosis filter is intended for the treatment of cold water only.

If the time needed to fill the storage tank has increased, it means that the pre-filters are exhausted, and it is necessary to urgently replace them. Delay with the replacement might damage or destroy the membrane. To avoid such critical situations, we strongly recommend to replace the set of pre-filters at least once in 3 months.     

If speed of filtration is decreasing significantly, it is necessary to replace the reverse osmosis membrane. We recommend to replace the membrane at least once a year.

In case there are long breaks (exceeding 2 weeks) in filter application, it is necessary to disinfect the filter (see detailed description of the procedure in the manual). When you are not planning to use the filter during a long period of time, it is recommended to turn off water supply to the filter.

Feed water requirements*

Parameter

Value**

pH

6.5–8.5

TDS, mg/L

<1500

Hardness, meq/L

<10.0

Active chlorine, mg/L

<0.5

Iron, mg/L

<0.3

Manganese, mg/L

<0.1

Chemical oxygen demand, mg O2/L

<5

Total microbial count (TMC), CFU per 1 mg

<50

Coli index

<3

* If the feed water condition does not correspond to the indicated requirements, service life of the membrane and replacement filters might decrease.

** In case of application of the filter for borehole or well water, it is recommended to make a preliminary chemical analysis of the water. If certain indicators exceed the values in the table, it is recommended to install additional filters before the reverse osmosis filter.

With all the questions, you are welcome to address our employees who are experienced specialists in the area of professional water treatment.   

     



Cookies

This Platform uses first- and third-party cookies to improve your experience and our services, analyzing browsing within the Platform. By continuing to browse you are accepting their use.

You can find more information or learn how to change the settings in our Cookie Policy.

By continuing to browse you are accepting their use.

Also you confirm that you have read and understood the Privacy Policy.