Dow Filmtec™ XLE-4040 is a high-performance reverse osmosis element with low energy consumption. Suitable for purification of water with medium level of mineralization. It provides high quality water at low operating costs.
The Dow Filmtec™ XLE-4040 membrane element operates at pressure minimal for reverse osmosis, by this reducing energy consumption.
Dow Filmtec™ membrane (USA) is the world standard for water purification
High energy efficiency due to low operating pressure
Large active surface of the element provides higher productivity
Automated high-precision production makes it possible to obtain elements with maximum active surface
Before launch of the reverse osmosis system preliminary preparation of the membrane, refill of the elements, adjustment of the devices and other system checks should be performed.
Avoid any major pressure or flow surges inside the spiral-wound elements in the middle of launch, stop, cleaning etc. to avoid risk of damage infliction to the membrane. During the launch it is recommended to gradually switch the system from standstill to operational mode following the steps:
gradually increase feed water pressure during 30-60 seconds
operational rate of the flows should be developed gradually during 15-20 seconds
permeate obtained within the first hour of operation is discharged
After the initial soaking, always keep the elements wet.
To prevent biofouling during long operation breaks it is recommended to submerge the membrane elements into preservative solutions.
Maximum pressure drop along the full length of the housing makes 2.1 bar.
Membrane type – spiral-wound element with polyamide thin-film composite
Nominal active surface, m2
Operating pressure, bar
Permeate volume, m3/day
Stabilized salt rejection, %
Permeate consumption and salt (NaCl) rejection are indicated for the following test conditions: 500 mg/L NaCl, 25°C and 15% permeate recovery.
Flow rates of permeate for every specific element might vary, but will not fluctuate by more than 15% from the indicated values.