New

Consumables and accessories

Scalex scale inhibitor replacement filter 2.5”x10”

Artnumber: PSE2510ECOEXP
€20
Article: PSE2510ECOEXP

Key advantages

  • Does not contain phosphates or polyphosphates, is harmless for humans and environment

  • Real capacity of 80 000 L

  • Up to 20% economy of gas and electric energy due to 100% capacity of the clean surface of heating elements

  • 100% protection of the boiler from sediment (100 micron nylon mesh)

  • 100% efficiency at high temperatures, operational temperature of heated water is up to 105 °С

The replacement filter sized 2.5"x10" is intended for protection of heat exchange units in double-pressure boilers from scale.

The technology reduces hardness and prevents their accumulation on the walls of heat exchange units in the boilers.   

In contrast to polyphosphate filters, this filter does not contain phosphates or polyphosphates, so it is harmless both for human’s health and environment.

Nylon mesh reduces the content of sediments larger than 100 micron including sand, silt and rust.

Benefits of using the filter

  • Longer service life of the boiler

  • Money saved by lower gas or electric power consumption

  • Easy replacement of the filter, no need to call service manager

The Scalex filter media prevents formation of scale and growth of lime crystals, as well as removes scale deposits.

As a result, scale is not being formed on the walls of heat exchange units in the boilers.

The Scalex filter media reacts to the quality of the water, and accordingly releases the relevant volume of the media necessary for hardness prevention.

The filter does not soften water, but comprehensively reduces hardness protecting heat exchange units of boilers from scale engaging 3 mechanisms:

  • it stops growth of scale crystals – special component of the media does not let crystals form into crystal lattice and deposit on surface of heating elements

  • destroys crystals by breaking them into smaller parts

  • impedes crystals from connecting by covering them and thus preventing from sticking to each other

Replacement manual

  1. Turn off water supply through the filter and make sure there is no pressure in the housing

  2. Screw the filter lid off the filter housing  

  3. Take the replacement filter out of the filter housing

  4. Wash the filter housing with tap water

  5. Put the new replacement filter inside the filter housing

  6. Assemble the filter

  7. Turn on water supply

  8. The filter is ready for further operation

The Scalex replacement filter 2.5"x10" is intended for cold tap water only.

Its capacity is up to 80 000 L.

The filter is recommended to be replaced every 6 months.