Cartridge filters

Filter1 sediment filter ½” for hot water

Artnumber: FPV12HWF1
19.00 USD
Article: FPV12HWF1

Key advantages:

  • Filter housing made of glass-filled polypropylene, optimal for hot water  

  • ½” NPT connection type

  • Filter housing made of pure European first-grade plastic

  • Protection of sanitary ware and plumbing

  • Compact and easy to install

Basic information

The Filter1 sediment filter ½” is intended for purification of hot water for household purposes from various sediments. Reduces content of sand, silt, rust, scale and other insoluble impurities larger than 5 micron in tap water.

Connection to plumbing is performed with brass bushings.

The filter housing is made of glass-filled polypropylene optimal for high temperatures.

Perfect for:

Premises with 1 bathroom, inhabited by up to 3 residents.

Benefits of using the filter:

  • Shower and bath with pure and transparent water

  • Sanitary ware and plumbing will be clean  

  • Shower and Jacuzzi sprayers will remain clean, water pressure will be high

  • Your home appliances, heating system and sanitary ware will work longer

Components of the filter:

  • Filter vessel

  • Polypropylene replacement filter

  • Rack

  • Service wrench

  • Screws

  • Passport

The filter vessel represents a transparent plastic bulb containing a replacement filter. Water flows through the polypropylene melt blown filter which effectively reduces sediment.



The filter is intended for purification of hot water.

Service life of the filter depends on water condition and volume of filtered water.

In the end of the service life the filter has to be replaced. Screw off the bulb with the service wrench. Take out the exhausted replacement filter, wash the bulb with tap water and insert the new replacement filter. Screw tight the filter housing back to the filter lid.

Installation of the filter should be performed by a qualified specialist.

To guarantee stable operation of the filter, and prevent accidents connected to pressure drops in pipes, it is recommended to employ a pressure valve installed into the pipeline right before the filter.

Characteristics of the equipment

Standard size  

2.5’’×10”

Mounting position

Vertical

Connection diameter

½”

Connection port

Brass

Maximum flow rate

10 L/min

Operating pressure

3.5-4 bar

Maximum pressure

8.6 bar

Temperature of water

+5…+75 °С

Maximum temperature

+80 °С